Bridge rectifier The purpose of this activity is to investigate the use of four diodes as a bridge rectifier. Written by Antoniu Miclaus and…
Category: StudentZone
ADALM2000: half- and full-wave rectifiers
The purpose of this activity is to investigate the use of a diode as a half-wave rectifier and two diodes as a full-wave rectifier.…
ADALM2000: diodes and diode circuits
The purpose of this activity is to investigate the current vs. voltage characteristics of a PN junction diode. Written by Antoniu Miclaus and Doug…
ADALM2000: measuring loop gain
The objective of this lab activity is to apply the voltage injection method using the ADALM2000 network analyser and a transformer to measure the…
One board, multiple instruments
Any electronics students and hobbyists need, at some point, to upgrade their hardware and start using equipment such as signal generators, oscilloscopes and logic…
Basic op amp configurations
Let's continue with the seventeenth part in the series with an introduction to op amp configurations. Written by Doug Mercer and Antoniu Miclaus Objective: In…
Measuring a loudspeaker impedance profile
After the introduction of the SMU ADALM1000 lets continue with the sixteenth part in the series with some small, basic measurements. Written by Doug Mercer and…
Impedance measurement/frequency effects
After the introduction of the SMU ADALM1000 lets continue with the fifteenth part in the series with some small, basic measurements. Written by Doug Mercer and…
Cascaded RC low-pass filters
After the introduction of the SMU ADALM1000 lets continue with the fourteenth part in the series with some small, basic measurements. Written by Doug…
Band-stop filters
After the introduction of the SMU ADALM1000 lets continue with the thirteenth part in the series with some small, basic measurements. Written by Doug…